View Single Post
Old 20-01-13, 00:24   #115
grunter01
YEEHAA
 
grunter01's Avatar
 
Join Date: 29-10-08
Location: Sydney, western suburbs
Car: nivara str,797hp 26/30 vl calais,vk calais,vectra
Trader Rating: (12)
PM me an offer

---------- Post added 20-01-13 at 10:45 ----------

HERE IS A RUN DOWN ON THE CAR AND WHAT IT HAS, CALL OR PM IF YOU ARE INTERESETED

Full chromoly 6 point roll cage including under dash bar, taxi bar, side intrusions, Re-enforcment bars to rear seat, complete bar out into boot for parachute mount.
DIEST Parachute with lever at shifter
NOS bottle holder with lines
Extinguisher
Full clip on removable steering wheel with transbrake button
Aluminium Sheet metal dash holding Stewart Warner 50mm Guages
VOLTS Gauge
WATER TEMP Gauge
OIL PRESSURE Gauge
BOOST Gauge
TRANS TEMP Gauge
FUEL PRESSURE Gauge
Dash also holds Autometer Tacho shift light and low oil pressure light
INNOVATE LM-1 METER,
INNOVATE LMA-3 MULTI SENSOR INPUT MODULE
Precision 3spd shifter
6AL MSD ignition
MSD Blaster coil
Transmission cooler with lines
Toggle control switch panel
Single piece JAZ pro stock drivers seat and Vinyl padded cover,
75mm race harness,
Morroso Oil Accumalator with Braided lines to engine bay
45ltr Fuel cell,
2 x Bosch 044 fuel pumps, brackets, check valves
EFI Fuel Regulator
FE2 suspention
Crysler shocks
Boxed trailing arms
9" diff
Disc brakes
35 spline axles
1/2" wheel studs
Strange alloy carrier 4.11's full spool,
WELD Racing wheels PRO STARS [Front] 24 x 4.5 x 15 with M/T Front runners [Rear] 26 x 11.5 x 15 with M/T ET STREETS.
Single 3.5" piece custom made Tailshaft with strange uni joints.
Brand new front bar
Bonnet pins
Shaven door locks

kirk 0410757949

---------- Post added 20-01-13 at 18:26 ----------

DID abit of work to the car today, Just put the new 9" in, also put the tail shaft and strengthend lower control arms then put in the cooler piping, And was that a fcuking prik of a job. Now just need to get the head re-torqued down then 35-40psi here we come. So hopefully have that done and retuned in the next 2 weeks. Also i think the diff has been shortened abit but wont know till i get new 1/2" wheel nuts.



Also this is the innovative logger that comes with the roller.


---------- Post added 20-01-13 at 18:57 ----------

THE ROLLER HAS RUN A BEST OF 9.06 @ 151mph. I want 8k for the car as it is which is ready to rumble with a box, engine, ecu.... If no one is interested in this thread i will advertise it. I know the car is worth this easily
__________________
ENVIRONMENTAL PROTECTION EQUIPMENT 0410757949

Last edited by grunter01; 20-01-13 at 17:28.
grunter01 is offline   Reply With Quote